Intructions
1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve
2. Connect the waste-disposal tube to the unit
3. Connect the power cord, and switch on the power switch (O=off, l=on)
4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18)
5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet)
Please note: This model trimmer comes with resin disc and no radiotube
Specifications
Voltage: <A>220V/50Hz±10% , <B>110V/60Hz±10%
Power: 500W
Rotational Speed: 2800 rpm
Dimensions: 44×35×35cm
Weight of the dental trimmer: 20kg
Looking for more
dental equipment at dentalget.com
0 out of 5 Stars
5 Star 0
4 Star 0
3 Star 0
2 Star 0
1 Star 0